Fujitsu M10-4 - Removing the Crossbar Cables

Caution -
Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see "1.5 Notes
Regarding Static Electricity"
A
14.2 Removing the Crossbar Cables
This section describes the procedure for removing the crossbar cables. Enable the
removal of the crossbar cables before attempting to remove them. For details, follow
the procedure in "Chapter 7 Maintenance Flow."
1.
Remove the two crossbar cables from the SPARC M10-4S.
Remove each crossbar cable by holding the tab (A
in the figure) of the cable and
pulling it straight out in the direction of the arrow. At this time, do not hold the
cable part when pulling out the crossbar cable. Pulling the cable part without the
connector lock completely released may cause damage.
Figure 14-6
Removing the crossbar cables
(electrical)
Chapter 14 Maintaining the Crossbar Cables 281