Fujitsu M10-4 - Chapter 5 Preparations Required for Maintenance; Preparing Tools Required for Maintenance

Caution -
Do not operate the target FRU while OpenBoot PROM is running (the ok
prompt is displayed). After powering off the physical partition or starting Oracle
Solaris, operate the target FRU.
Table 5-1
Maintenance tools
Item Use
Phillips screwdriver (No.2) Removing or replacing screws
Flathead screwdriver (small) Used when installing the CPU memory unit upper
Wrist strap For grounding static electricity
ESD mat For grounding static electricity
Chapter 5
Preparations Required for
Maintenance
This chapter describes the preparations before you can physically remove an FRU.
■
Preparing Tools Required for Maintenance
■
Switching the Mode Switch to Service Mode
■
Preparations for Enabling Active Maintenance
■
Powering Off the Physical Partition Requiring Maintenance
■
Stopping the Entire System
■
Saving XSCF Setting Information
■
Releasing a SPARC M10-4/M10-4S FRU from the System with the replacefru
Command
5.1 Preparing Tools Required for
Maintenance
Table 5-1 lists the tools required for FRU maintenance.
53