EasyManua.ls Logo

Fujitsu M10-4 - Chapter 14 Maintaining The Crossbar Cables; Configuration of the Ports for the Crossbar Cables

Fujitsu M10-4
342 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter
14
Maintaining
the
Crossbar
Cables
This
chapter
describes
the
procedures
for
maintaining
the
crossbar
cables.
■
Configuration
of
the
Ports
for
the
Crossbar
Cables
■
Removing
the
Crossbar
Cables
■
Installing
the
Crossbar
Cables
14.1 Configuration
of
the
Ports
for
the
Crossbar
Cables
This
section
describes
the
configuration
and
locations
of
the
ports
for
connecting
the
crossbar
cables.
The
crossbar
cables
are
used
to
connect
the
SPARC
M10-4S
units
to
one
another
or
to
connect
the
SPARC
M10-4S
to
a
crossbar
box
in
a
building
block
configuration
(with
a
crossbar
box).
Each
crossbar
cable
has
a
number
that
corresponds
to
a
port
number
on
the
chassis.
A
port
number
is
assigned
to
each
pair
of
ports.
So
crossbar
cables
should
be
replaced
as
a
pair.
277

Table of Contents

Related product manuals