Fujitsu M10-4 - Stopping the System from the Operation Panel; Saving XSCF Setting Information

Note -
For a building block configuration, press the power switch on the master chassis. The
power switches of the other chassis are disabled.
Note -
For a building block configuration, check the POWER LEDs on all the chassis that
make up the system.
XSCF>

showpparstatus

-a
PPAR-ID

PPAR

Status
00

Powered

Off
01

Powered

Off
02

Powered

Off

XSCF>

showdomainstatus

-p

0
Logical

Domain

Name

Status
primary

Solaris

powering

down
4S-159-D0-G0

Solaris

powering

down
4S-159-D0-G1

Solaris

powering

down
4S-159-D0-G2

Solaris

powering

down

5.6.2 Stopping the system from the operation panel
1.
Confirm that the mode switch on the operation panel is in Service mode.
2.
Press the power switch on the oper ation panel for 4 seconds or more.
For details, see "2.3.2 Control function of the operation panel"
3.
Check that the POWER LED on the operation panel is off.
4.
Execute the show pparstatus
command to confirm that the power to the
physical partition is turned off.
In the following example, [PPAR Status] displays "Powered Off" for PPAR-IDs
00, 01, and 02, indicating that the power to all the physical partitions has been
turned off.
5.
Execute the showdomainstatus command to check the operating condition of
the logical domain.
In the following example, [Status] displays "Solaris powering down" for the
logical domains, indicating that Oracle Solaris is shutting down.
5.7 Saving XSCF Setting Information
This section describes how to save the following XSCF setting information:
Chapter 5 Preparations Required for Maintenance 75