Fujitsu M10-4 - Page 126

Table 7-1
Maintenance workflow
Item
Procedure Reference
1 Identifying the FRU to be replaced "4.2.2 Identifying a failure"
2 Checking the available maintenance
types (*1)
"Table 7-2 List of available maintenance types
by FRU"
3 Active maintenance (*2)
3-a Active replacement "7.2.1 Active replacement"
3-b Active addition "7.3.1 Active addition"
3-c Active removal "7.4.1 Active removal"
4Inactive maintenance
4-a Inactive replacement "7.2.2 Inactive replacement"
4-b Inactive addition "7.3.2 Inactive
addition"
4-c Inactive removal "7.4.2 Inactive removal"
5 System-stopped maintenance
5-a System-stopped replacement "7.2.3 System-stopped replacement"
5-b System-stopped addition "7.3.3 System-stopped addition"
5-c System-stopped removal "7.4.3 System-stopped removal"
*1 The configuration of the system requiring maintenance and the FRU to be replaced may
affect system operation, such as in maintenance time and in stopping the logical domains.
Consult
with the system administrator to decide the maintenance type to be used.
*2 To perform PCIe card maintenance using PHP, confirm that the card is PHP enabled. To
do so, check "Appendix A Cards that Support PCI Hot Plug and Dynamic Reconfiguration" in
the Fujitsu M10/SPARC M10 Systems PCI Card Installation Guide.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 2014112