Fujitsu M10-4 - Page 303

Note -
When installing a crossbar unit, insert it to the back of the device with the eject levers
kept open. That is, leave the levers in their up and down positions. If you close the eject
levers before inserting the crossbar unit, you cannot install it.
Once you insert the crossbar
unit to the back of the device, the eject levers move in the
directions of their closed positions. Push the eject levers by hand to securely close them.
Note -
Connect the crossbar cables correctly according to the corresponding cable position
labels.
1.
Open the eject levers of the crossbar unit.
2.
Support the cross bar unit from below with one hand and then carefully insert
it into the mounting frame.
3.
Close the eject levers and tighten the two screws securing the cros sbar unit.
4.
Connect all the cros sbar cables to the crossbar unit.
Chapter 15 Maintaining the Crossbar Units 289