Fujitsu M10-4 - Page 65

filler unit that has been stored in a safe place onto the empty slot.
Note the following points when performing PCIe card removal:
■
Release the multipath depending on the use of a PCIe card when performing
active/hot maintenance or active/cold maintenance with PHP.
■
For active removal by PHP, confirm that the card is PHP supported. To do so,
check "Appendix A Cards that Support PCI Hot Plug and Dynamic Reconfig uratio n "
in the Fujitsu M10/SPARC M10 Systems PCI Card Installation Guide.To perform
active removal using PHP combined with dynamic SR-IOV and the dynamic
reconfiguration function of PCIe end point devices, check the applicable cards by
referring to "Appendix B Cards that Support SR-IOV" or "Appendix D Cards
that support the dynamic
reassignment function for the PCIe end point device
(PCIe card)" in the same manual.
■
When performing PCIe card removal, remove the PCIe card from the PCIe card
cassette and then attach the filler that has been stored in a safe place.
Chapter 4 Preparation and Precautions for Maintenance 51