Fujitsu M10-4 - Page 76

#

cfgadm

-a
Ap_Id

Type

Receptacle

Occupant

Condition
BB#0-PCI#0

pci-pci/hp

connected

configured

ok
#

cfgadm

-c

unconfigure

<Ap_Id>
#

cfgadm

-c

disconnect

<Ap_Id>
#

cfgadm

-a
Ap_Id

Type

Receptacle

Occupant

Condition
BB#0-PCI#0

unknown

disconnected

unconfigured

unknown
#

cfgadm

-x

led=attn,mode=blink

<Ap_Id>
3.
Release the target PCI Express card from the logical domain (control domain
or root domain).
4.
Stop the power supply to the target PCI Express card.
5.
Confirm that the PCI Express card has been released from the control domain.
In the above example, [Receptacle] and [Occupant] display "disconnected" and
"unconfigured," respectively, which indicates that the PCI Express card mounted
at BB#0-PCI#0 has been released from the logical domain.
6.
Set the ATTENTION LED of the target PCI Express card cassette to blink.
For removal, this work is not required.
7.
Check the
following LEDs to determine whether the PCI Express card can be
removed.
- The ATTENTION LED (amber) of the PCI Express card is blinking.
- The POWER LED of the PCI Express card is off.
For removal, the ATTENTION LED (amber) does not blink. Make sure that the
POWER LED is off.
Enabling the removal of an internal disk
How to identify a disk slot
To perform active replacement of an internal disk drive, you need to know the
physical device name or logical device name of a drive to be installed or removed. If
a disk error occurs in the system, from the system console, you can normally check
for messages regarding a disk that
is likely to fail or that has already failed. This
information is also recorded in the /var/adm/messages file.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 201462