▶
Pull the HDD/SSD module completely out of its bay.
Installing a 2.5-inch HDD/SSD dummy module
CAUTION
▶
If the removed HDD/SSD module is not replaced immediately,
always replace a dummy module into the unused HDD/SSD bay to
comply with applicable EMC regulations and satisfy cooling
requirements.
Figure 89: Installing the 2.5-inch HDD/SSD dummy module
▶
Push the dummy module into the empty bay until it engages.
▶
If applicable, insert the dummy lock.
Concluding steps
No steps needed.
Hard disk drive (HDD) / solid state disk (SSD)
RX2520 M5 Upgrade and Maintenance Manual 177
To Next Page
Loading...
