12.4.3 Replacing the LTO drive
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
Ask the system administrator to eject all remaining backup or optical media
from the backup or ODD before removing it from the server.
▶
"Locating the defective server" on page
43.
▶
"Suspending BitLocker functionality" on page 65.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 47.
▶
"Removing the air duct" on page 58.
▶
"Removing the fan holder" on page 60.
▶
"Removing the front panel cage" on page 347.
Removing the defective LTO drive
▶
Remove the LTO drive, see "Removing the LTO drive" on page 327.
Installing the new LTO drive
▶
Install the LTO drive, see "Installing the LTO drive" on page 319.
Concluding steps
▶
"Installing the front panel cage" on page 355.
▶
"Installing the fan holder" on page 61.
▶
"Installing the air duct" on page 59.
Accessible drives
RX2520 M5 Upgrade and Maintenance Manual 333
To Next Page
Loading...
