Concluding steps
▶
"Installing the air duct" on page 59.
▶
"Reassembling" on page
51.
▶
"Connecting the power cord" on page 56.
▶
"Switching on the server" on page 57.
▶
"Resuming BitLocker functionality" on page 88.
▶
Enable the TPM in the system board BIOS, see "Enabling the TPM in the
system board BIOS" on page 394.
Enabling the TPM in the system board BIOS
Proceed as follows:
▶
Switch on or restart your server.
▶
As soon as the startup screen appears, press the [F2] function key to enter
the BIOS setup menu.
▶
Select the Advanced menu.
▶
Select the Trusted Computing submenu.
▶
Set the TPM Support and TPM State settings to Enabled.
▶
Under Pending TPM operation, select the desired TPM operation mode.
▶
Save your changes and exit the BIOS.
For information on how to access the BIOS and modify settings, see the
corresponding BIOS Setup Utility reference manual.
15.4.3 Removing the TPM
Field Replaceable Unit
(FRU)
Hardware: 30 minutes
System board and components
394 Upgrade and Maintenance Manual RX2520 M5
To Next Page
Loading...
