▶
Insert all dummy modules, see "Installing a 2.5-inch HDD/SSD dummy
module" on page 177
.
▶
"Reassembling" on page 51.
▶
"Connecting the power cord" on page 56.
▶
"Switching on the server" on page 57.
▶
"Resuming BitLocker functionality" on page 88.
7.5.9 Upgrading from 8x to 16x 2.5-inch HDD/SSD
configuration
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Software: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Suspending BitLocker functionality" on page 65
.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 47.
▶
"Removing the air duct" on page 58.
▶
"Removing the fan holder" on page 60.
Installing the second 2.5-inch HDD backplane
▶
Install the second backplane, see "Installing a 2.5-inch HDD backplane" on
page 187.
▶
Connect the cables to the second backplane, see "Connecting a 2.5-inch
HDD backplane" on page 188.
▶
Connect the power cable from the second backplane to connector "PWR2"
on the system board.
Hard disk drive (HDD) / solid state disk (SSD)
190 Upgrade and Maintenance Manual RX2520 M5
To Next Page
Loading...
