81901A “MSW_GPC-40/600A”_03-2021_ENG_page 37
3.11.10. E2 energy consumption meter reset
Address
Format
GPC-OP
menu
Acronym
Global /
M/E1/E2
GF_eXpress menu
Attribute
Retentive
Type
Unit of mea-
surement
Default
Single-
node
Multi-
node
Description
1139
115 bit
BIT_
RESET_
LDE2
M
MainMenu → M → Expert →
Bit → BIT_RESET_LDE2_1
R/W OFF2163 E1
MainMenu → E1 → Expert →
Bit → BIT_RESET_LDE2_2
4211 E2
MainMenu → E2 → Expert →
Bit → BIT_RESET_LDE2_3
The parameter sets the reset function of the E2 energy meter.
Options: OFF = Function is disabled
ON = The function is enabled. The meter Ld.E2 is reset to zero.
3.12. Digital inputs
The following functions are related to the digital inputs:
• Automatic / manual control (see paragraph “3.22. Auto-
matic - manual control”).
• Alarm memory reset (see paragraph “3.13.13. Alarm
memory reset”).
• Software shutdown / startup (see paragraph “3.25.
Software shutdown”).
• Reference Feedback calibration (see paragraph
“3.31.9. Feedback reference calibration”).
• HB alarm calibration (see diagrams “Functional dia-
gram of HB calibration in ZC - BF - HSC mode” on
page 61, “Functional diagram of HB calibration in
PA mode” on page 61, “Functional diagram of HB
calibration for infrared lamps” on page 62).
For further explanations on the use and configuration of the
digital inputs, see paragraphs:
• “4.2. Using a function associated with the digital input
and via serial”,
• “4.3. Using digital input 1 to enable software startup”,
particularly the examples chapter.
The following functional diagram shows the signal process-
ing sequences of the digital inputs.
To Next Page
Loading...
