gefran GPC - Direct Setting of a Direct or Reverse Alarm

81901A “MSW_GPC-40/600A”_03-2021_ENG_page 51
3.13.6. Direct setting of a direct or reverse alarm
Address
Format
GPC-OP
menu
Acronym
Global / M/E1/E2
GF_eXpress menu
Attribute Retentive Type Unit of mea- surement Default
Single-
node
Multi-
node
Description
1070
46 bit
BIT_
AL1_
DIR_INV
M
MainMenu → M → Expert →
Bit → BIT_AL1_DIR_INV_1
R/W
■
OFF2094 E1
MainMenu → E1 → Expert →
Bit → BIT_AL1_DIR_INV_2
4142 E2
MainMenu → E2 → Expert →
Bit → BIT_AL1_DIR_INV_3
1078
54 bit
BIT_
AL2_
DIR_INV
M
MainMenu → M → Expert →
Bit → BIT_AL2_DIR_INV_1
R/W
■
OFF2102 E1
MainMenu → E1 → Expert →
Bit → BIT_AL2_DIR_INV_2
4150 E2
MainMenu → E2 → Expert →
Bit → BIT_AL2_DIR_INV_3
1060
36 bit
BIT_
AL3_
DIR_INV
M
MainMenu → M → Expert →
Bit → BIT_AL3_DIR_INV_1
R/W
■
OFF2084 E1
MainMenu → E1 → Expert →
Bit → BIT_AL3_DIR_INV_2
4132 E2
MainMenu → E2 → Expert →
Bit → BIT_AL3_DIR_INV_3
1094
70 bit
BIT_
AL4_
DIR_INV
M
MainMenu → M → Expert →
Bit → BIT_AL4_DIR_INV_1
R/W
■
OFF2118 E1
MainMenu → E1 → Expert →
Bit → BIT_AL4_DIR_INV_2
4166 E2
MainMenu → E2 → Expert →
Bit → BIT_AL4_DIR_INV_3
The parameter sets the direct or reverse mode for alarms 1, 2, 3 and 4, depending on the address used.
Options: OFF = Direct alarm (maximum)
ON = Reverse alarm (minimum)