Gerber Solara ion User Manual

CHAPTER 5
63
Printing Jobs on the GERBER SOLARA ION
4/29/10 Rev G
3 Press ENTER to display the
Lamp Delay screen.
4 Use the arrow keys to select
ON and then press ENTER. To disable Lamp Delay, select
OFF and then press ENTER.
Lamp Spec mode
Lamp Spec mode is a special UV lamp setting that may be helpful for certain materials that
need extra heat to cure ink. Lamp Spec mode activates the UV lamps at a higher temperature
than normal and warms the material for 45-60 seconds prior to the start of the job. The lamp
warm-up cycle is longer when the printer is set to Lamp Spec mode.
Lamp Spec mode is set in the Setup section of the printer Menu or on the System Settings web
page. The default setting for Lamp Spec Mode is Normal.
Note: Lamp Spec mode may or may not increase the curing success of some materials. Gerber
suggests using Gerber-qualified materials for the best results.
To activate Lamp Spec mode from the printer’s menu
1 From the main control panel press the MENU key. The Status screen displays.
2 Press the  or  key until the
Setup screen displays.
3 Press ENTER to display the
Lamp Delay screen.
4 Press the  or  key until the
Lamp Spec Mode screen displays, and then press ENTER.
5 Use the arrow keys to select
High and then press ENTER. To disable Lamp Spec Mode,
select
Normal and then press ENTER.
Setup
Lamp Delay
ON OFF
Status
Setup
Lamp Spec Mode
Normal High

Gerber Solara ion Specifications

General

Brand	Gerber
Model	Solara ion
Category	Printer
Language	English