CHAPTER 3
33
Setting up the GERBER SOLARA ION
4/29/10 Rev G
6 Enter a Subnet Mask address in the field. The default Subnet Mask of 255.255.255.000
is normally acceptable for most networks. The Subnet Mask should be the same for the
computer and the printer.
7 Enter a Gateway address in the field. The Gateway address can be left at the default
setting of 000.000.000.000 in a single LAN environment. If you are connected across
multiple LANs, contact your network administrator for the correct address.
8 Click the Change Settings button to accept the new values.
9 The printer prompts you power-cycle the system in order for it to update and utilize
the newly entered values.
Setting the IP Address and Subnet Mask of your computer
When using Fixed network settings, the default IP address of the Gerber Solara ion is
192.168.000.050 and the default Subnet mask is 255.255.255.000. The following procedure uses
192.168.000.001 for the computer's IP address and 255.255.255.000 for the Subnet mask. Use the
procedure that matches your configuration: Windows® Vista or Windows XP.
CAUTION: Use care when entering addresses for the equipment. Entering incorrect
addresses could damage the network. In a large existing network, obtain the correct
addresses for the computer and the Gerber Solara ion from the network
administrator or IT Professional.
To set the IP Address and Subnet Mask for Windows Vista or Windows 7
Note: You must be logged on as an Administrator to configure network settings in Windows
Vista or Windows 7.
1 Click Start > Control Panel to open the Control Panel dialog box. Your display might
look different if you are in Classic View. You can switch between Classic and Category
View under Control Panel Home on the left side of the window.
2 Click Network and Internet to open the Network and Internet dialog box.
To Next Page
Loading...
Need help?
General
