Firmware Version 1.0.1.12
UCM6510 IP PBX User Manual
Email address can be found for the user, send the received Fax to the
default Email address in Fax setting page under web GUI->PBX->Internal
Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
This option controls how the extension can be used on devices within
different types of network.
Allow All
Device in any network can register this extension.
Local Subnet Only
Only the user in specific subnet can register this extension. Up to three
subnet addresses can be specified.
A Specific IP Address.
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, ILBC,
ADPCM, LPC10, H.264, H.263 and H.263p. In the selected codec list,
users can click on UP or DOWN arrow to adjust the order for the codec
priority.
EDIT EXTENSION
All the UCM6510 extensions are listed under web GUI->PBX->Basic/Call Routes->Extensions, with
status, Extension, CallerID Name, Technology (SIP, IAX and FXS), IP and Port. Each extension has a
checkbox for users to "Modify Selected Extensions" or "Delete Selected Extensions". Also, options
"Edit" , "Reboot" and "Delete" are available per extension.
Status
Users can see the following icon for each extension to indicate the SIP status.
Green: Free
Blue: Ringing
To Next Page
Loading...