Firmware Version 1.0.1.12
UCM6510 IP PBX User Manual
1. Make sure the feature code for "Audio Mix Record" is configured and enabled.
2. After establishing the call, enter the "Audio Mix Record" feature code (by default *3) followed by # or
SEND to start recording.
3. To stop the recording, enter the "Audio Mix Record" feature code (by default *3) followed by # or SEND
again. Or the recording will be stopped once the call hangs up.
4. The recording file can be retrieved under web GUI->Status->CDR. Click on to play the recording
or click on to download the recording file.
Figure 113: Download Recording File from CDR Page
The above recorded call's recording files are also listed under the UCM6510 web GUI->CDR->Recording
Files.
CALL PARK
The UCM6510 provides call park and call pickup features via feature code.
PARK A CALL
There are two feature codes that can be used to park the call.
ï‚· Feature Maps->Call Park (Default code #72)
During an active call, press #72 and the call will be parked. Parking lot number (default range 701 to
720) will be announced after parking the call.
ï‚· Feature Misc->Call Park (Default code 700)
During an active call, initiate blind transfer (default code #1) and then dial 700 to park the call. Parking
lot number (default range 701 to 720) will be announced after parking the call.
To Next Page
Loading...
Need help?
General