Grandstream Networks UCM6510 IP PBX - Blacklist Configurations

Firmware Version 1.0.1.12
UCM6510 IP PBX User Manual
Page 158 of 277
 Paging/Intercom Group
 IVR
 Voicemail Groups
 Fax Extension
 Dial By Name
Alert-Info
When present in an INVITE request, the Alert-Info header field specifies an
alternative ring tone to the UAS.
Time Condition
Start Time
Select the start time "hour:minute" for the trunk to use the inbound rule.
End Time
Select the end time "hour:minute" for the trunk to use the inbound rule.
Date
Select "By Week" or "By Day" and specify the date for the trunk to use the
inbound rule.
Week
Select the day in the week to use the inbound rule.
Destination
Select the destination for the inbound call under the defined time condition.
 Extension
 Voicemail
 Conference Room
 Call Queue
 Ring Group
 Paging/Intercom
 Voicemail Group
 Fax
 DISA
 IVR
 By DID
When "By DID" is used, the UCM6510 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination". If the dialed number matches the DID pattern, the call will
be allowed to go through.
Configure the number of digits to be stripped in "Strip" option.
 Dial By Name
BLACKLIST CONFIGURATIONS
In the UCM6510, Blacklist is supported for all inbound routes. Users could enable the Blacklist feature,
manage the Blacklist by clicking on "Blacklist".