Firmware Version 1.0.1.12
UCM6510 IP PBX User Manual
Create a name for the model template.
Enter a description for the model template. This is optional.
Select to assign this model template as the default model template. The
value of the option in default model template will be overridden if other
selected model template has a different value for the same option.
Check this option to enable the model template.
Click on to edit the model template.
The editing window for model template is shown in the following figure. In the “Options” field, enter the
option name key word, the option that contains the key word will be listed. User could then select the
option and click on “Add Option” to add it into the model template.
Once added, the option will be shown in the list below. On the left side of each option, users can click
on to remove this option from the model template. On the right side of each option, users can click
on to reset the option to the default value.
Figure 38: Edit Model Template
To Next Page
Loading...