Firmware Version 1.0.1.12
UCM6510 IP PBX User Manual
INTERNAL OPTIONS
This section describes internal options that haven't been mentioned in previous sections yet. The settings
in this section can be applied globally to the UCM6510, including general configurations, jitter buffer, RTP
settings, hardware config and STUN monitor. The options can be accessed via web GUI->PBX->Internal
Options.
INTERNAL OPTIONS/GENERAL
Table 63: Internal Options/General
Configure the global CallerID used for all outbound calls when no other
CallerID is defined with higher priority. If no CallerID is defined for
extension or trunk, the global outbound CID will be used as CallerID.
Configure the global CallerID Name used for all outbound calls. If
configured, all outbound calls will have the CallerID Name set to this name.
If not, the extension's CallerID Name will be used.
Specify the operator extension, which will be dialed when users presses 0
to exit voicemail application. The operator extension can also be used in
IVR option.
Configure the number of seconds to ring an extension before the call goes
to the user's voicemail box. The default setting is 60.
Note:
This is the global value used for each extension if "Ring Timeout" field is
left empty on the extension configuration page.
If enabled, users will hear voice prompt before recording is started or
stopped. For example, before recording, the UCM6510 will play voice
prompt "The call will be recorded". The default setting is "No".
If enabled, strong password will be enforced for the password created on
the UCM6510. The default setting is enabled.
Strong Password Rules:
1. Password for voicemail, voicemail group, outbound route, DISA, call
queue and conference requires non-repetitive and non-sequential
To Next Page
Loading...
Need help?
General