Firmware Version 1.0.1.12
UCM6510 IP PBX User Manual
EMAIL TO USER
Once the extensions are created with Email address, the PBX administrator can click on button “Email To
User” to send the account registration and configuration information to the user. Please make sure Email
setting under web UI->Settings->Email Settings is properly configured and tested on the UCM6510
before using “Email To User”.
When click on “Email To User” button, the following message will be prompted in the web page. Click on
OK to confirm sending the account information to all users’ Email addresses.
Figure 54: Email To User: Prompt Information
The user will receive Email including account registration information and LDAP configuration. A QR
code is also generated for Mobile applications to scan it and get automatically provisioned. QR code
provisioning is supported on Grandstream Softphone GS Wave Android
TM
application.
Figure 55: Email To User: Account Registration Information and QR Code
To Next Page
Loading...
Need help?
General