To Next Page

To Previous Page

Firmware Version 1.0.1.12

UCM6510 IP PBX User Manual

Page 106 of 277

default Email address in Fax setting page under web GUI->PBX->Internal

Options->Fax/T.38.

Note:

If enabled, Fax Pass-through cannot be used.

Skip Trunk Auth

If enabled, users will not need enter the "PIN Set" required by the

outbound rule to make outbound calls. The default setting is "No".

Dial Trunk Password

Configure personal password when making outbound calls via trunk.

Strategy

This option controls how the extension can be used on devices within

different types of network.

 Allow All

Device in any network can register this extension.

 Local Subnet Only

Only the user in specific subnet can register this extension. Up to three

subnet addresses can be specified.

 A Specific IP Address

Only the device on the specific IP address can register this extension.

The default setting is "Allow All".

Codec Preference

Select audio and video codec for the extension. The available codecs are:

PCMU, PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723, ILBC,

ADPCM, H.264, H.263 and H.263p. In the selected codec list, users can

click on UP or DOWN arrow to adjust the order for the codec priority.

Specific Time

Time Condition

Click to add Time Condition to configure specific time for this extension.

BATCH ADD EXTENSIONS

BATCH ADD SIP EXTENSIONS

In order to add multiple SIP extensions, BATCH add can be used to create standardized SIP extension

accounts. However, unique extension user name can’t be set using BATCH add.

Under web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add

SIP Extensions".

Grandstream Networks UCM6510 IP PBX User Manual

Questions and Answers: