Grandstream Networks UCM6510 IP PBX User Manual

Firmware Version 1.0.1.12
UCM6510 IP PBX User Manual
Page 144 of 277
 Auto: Use RFC2833 if offered; otherwise Inband will be used
Enable Qualify
If enabled, the UCM6510 will regularly send SIP OPTIONS to the device to
check if the device is still online. The default setting is "No".
Qualify Timeout
When "Enable Qualify" option is set to "Yes", configure the timeout (in ms)
for the Qualify SIP message. If no response is received within the timeout,
the device is considered offline. The default setting is 1000ms.
Qualify Frequency
When "Enable Qualify" option is set to "Yes", configure the interval (in
seconds) of the SIP OPTIONS message sent to the device to check if the
device is still online. The default setting is 60 seconds.
The maximum number of call
lines
Configure the maximum number of concurrent calls allowed over the trunk
at the same time. The default value is 0 meaning no limit.
Fax Detection
Enable to detect Fax signal from the trunk during the call and send the
received Fax to the default Email address in Fax setting page under web
GUI->PBX->Internal Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
SRTP
Enable SRTP for the VoIP trunk. The default setting is "No".
Table 43: IAX Trunk Configuration Parameters
Create New IAX Trunk
Type
Select the VoIP trunk type.
 Peer IAX Trunk
 Register IAX Trunk
Provider Name
Configure a unique label to identify this trunk when listed in outbound rules,
inbound rules and etc.
Host Name
Configure the IP address or URL for the VoIP provider’s server of the trunk.
Keep Trunk CID
If enabled, the trunk CID will not be overridden by extension's CID when
the extension has CID configured. The default setting is "No".
Username
Enter the username to register to the trunk from the provider when
"Register IAX Trunk" type is selected.
Disable This Trunk
If selected, the trunk will be disabled.
Password
Enter the password to register to the trunk from the provider when
"Register IAX Trunk" type is selected.
Peer IAX Trunk Configuration Parameters
Provider Name
Configure the provider name for the VoIP trunk. This is a unique label to
identify the trunk when listed in outbound rules, inbound rules and etc.

Grandstream Networks UCM6510 IP PBX Specifications

General

Brand	Grandstream Networks
Model	UCM6510 IP PBX
Category	Processor
Language	English