To Next Page

To Previous Page

Firmware Version 1.0.1.12

UCM6510 IP PBX User Manual

Page 264 of 277

Table 88: Network Upgrade Configuration

Upgrade Via

Allow users to choose the firmware upgrade method: TFTP, HTTP or

HTTPS.

Firmware Server Path

Define the server path for the firmware server.

Firmware File Prefix

If configured, only the firmware with the matching encrypted prefix will be

downloaded and flashed into the UCM6510.

Firmware File Suffix

If configured, only the firmware with the matching encrypted postfix will be

downloaded and flashed into the UCM6510.

HTTP/HTTPS User Name

The user name for the HTTP/HTTPS server.

HTTP/HTTPS Password

The password for the HTTP/HTTPS server.

Please follow the steps below to upgrade the firmware remotely.

 Enter the firmware server path under web GUI->Maintenance->Upgrade.

 Click on "Save". Then reboot the device to start the upgrading process.

 Please be patient during the upgrading process. Once done, a reboot message will be displayed in the

LCD.

 Manually reboot the UCM6510 when it's appropriate to avoid immediate service interruption. After it

boots up, log in the web GUI to check the firmware version.

UPGRADING VIA LOCAL UPLOAD

If there is no HTTP/TFTP server, users could also upload the firmware to the UCM6510 directly via web

GUI. Please follow the steps below to upload firmware locally.

1. Download the latest UCM6510 firmware file from the following link and save it in your PC.

http://www.grandstream.com/support/firmware

2. Log in the web GUI as administrator in the PC.

3. Go to web GUI->Maintenance->Upgrade, upload the firmware file by clicking on and select the

firmware file from your PC. The default firmware file name is ucm6510fw.bin

Figure 139: Local Upgrade

Grandstream Networks UCM6510 IP PBX User Manual

Questions and Answers: