To Next Page

To Previous Page

Firmware Version 1.0.1.12

UCM6510 IP PBX User Manual

Page 219 of 277

Deactivate

Feature Misc

Feature Code Digits Timeout

Default Setting: 1000.

Configure the maximum interval (in milliseconds) between the

digits input to activate the feature code.

Call Park

 Default Extension: 700.

 During an active call, initiate blind transfer and then enter this

code to park the call.

Parked Lots

 Default Extension: 701-720.

 These are the extensions where the calls will be parked, i.e.,

parking lots that the parked calls can be retrieved.

Use parklot as extension

If checked, the parklot number will be used as extension, you

can transfer to the parklot number for parking your call. If the

parking lots overlap existing extensions, there will be conflict.

Parking Timeout (s)

 Default setting: 300.

 This is the timeout allowed for a call to be parked. After the

timeout, if the call is not picked up, the extension who parks the

call will be called back.

Feature Codes

Voicemail Access Code

 Default Code: *98.

 Enter *98 and follow the voice prompt. Or dial *98 followed by

the extension and # to access the entered extension's voicemail

box.

My Voicemail

 Default Code: *97.

 Press *97 to access the voicemail box.

Agent Pause

 Default Code: *83.

 Pause the agent in all call queues.

Agent Unpause

 Default Code: *84.

 Unpause the agent in all call queues.

Paging Prefix

 Default Code: *81.

 To page an extension, enter the code followed by the extension

number.

Intercom Prefix

 Default Code: *80.

 To intercom an extension, enter the code followed by the

extension number.

Blacklist Add

 Default Code: *40.

 To add a number to blacklist for inbound route, dial *40 and

Brand	Grandstream Networks
Model	UCM6510 IP PBX
Category	Processor
Language	English

Grandstream Networks UCM6510 IP PBX User Manual

Table of Contents

Questions and Answers:

Grandstream Networks UCM6510 IP PBX Specifications