Grandstream Networks UCM6510 IP PBX User Manual

Firmware Version 1.0.1.12
UCM6510 IP PBX User Manual
Page 236 of 277
This setting doesn't apply to calls on hold.
RTP Hold Timeout
When the call is on hold, if there is no RTP activity within the timeout (in
seconds), the call will be terminated. This value of RTP Hold Timeout
should be larger than RTP Timeout. The default setting is no timeout.
Trust Remote Party ID
Configure whether the Remote-Party-ID should be trusted. The default
setting is "No".
Send Remote Party ID
Configure whether the Remote-Party-ID should be sent or not. The default
setting is "No".
Generate In-Band Ringing
Configure whether the UCM6510 should generate inband ringing or not.
The default setting is "Never".
 Yes: The UCM6510 will send 180 Ringing followed by 183 Session
Progress and in-band audio.
 No: The UCM6510 will send 180 Ringing if 183 Session Progress has
not been sent yet. If audio path is established already with 183 then
send in-band ringing.
 Never: Whenever ringing occurs, the UCM6510 will send 180 Ringing
as long as 200OK has not been set yet. Inband ringing will not be
generated even the end point device is not working properly.
Server User Agent
Configure the user agent string for the UCM6510.
Send Compact SIP Headers
If enabled, compact SIP headers will be sent. The default setting is "No".
Add "user=phone" to URI
If enabled, "user=phone" will be added to URI that contains a valid phone
number. The default setting is "No".

Grandstream Networks UCM6510 IP PBX Specifications

General

Brand	Grandstream Networks
Model	UCM6510 IP PBX
Category	Processor
Language	English