H3C WA Series User Manual

209
Item Descri
p
tion
Send accounting-on
packets
Enable or disable the accounting-on feature.
The accounting-on feature enables a device to send accounting-on packets to
RADIUS servers after it reboots, making the servers forcedly log out users who
logged in through the device before the reboot.
IMPORTANT:
When enabling the accounting-on feature on a device for the first time, you must save
the configuration so that the feature takes effect after the device reboots.
Accounting-On Interval Not supported on the AP.
Accounting-On Attempts Not supported on the AP.
Attribute
Enable or disable the device to interpret the RADIUS class attribute as CAR
parameters.
Not supported on the AP.
Interpretation
7. In the RADIUS Server Configuration area, click Add to enter the RADIUS server configuration page.
Figure 203 RADIUS server configuration page
8. Configure a RADIUS server for the RADIUS scheme as described in Table 83.
9. Click Apply to add the server to the RADIUS scheme.
10. Repeat step 7 through step 9 to add more RADIUS servers to the RADIUS scheme.
11. On the RADIUS scheme configuration page, click Apply.
Table 83 Configuration items
Item Descri
p
tion
Server Type
Select the type of the RADIUS server to be configured. Possible values include
primary authentication server, primary accounting server, secondary
authentication server, and secondary accounting server.
IP Address
Specify the IPv4 or IPv6 address of the RADIUS server.
IMPORTANT:
• The primary and secondary authentication servers must use different IP
addresses. The primary and secondary accounting servers must use different IP
addresses.
• RADIUS servers in the same RADIUS scheme must use the same IP version.
Port Specify the UDP port of the RADIUS server.

H3C WA Series Specifications

General

Brand	H3C
Model	WA Series
Category	Wireless Access Point
Language	English