362
Figure 392 Configuring a rule for a basic IPv6 ACL
3. Configure the basic IPv6 ACL rule information as described in Table 117.
4. Click Add.
Table 117 Configuration items
Item Descri
tion
Select Access Control List
(ACL)
Select the basic IPv6 ACL for which you want to configure rules.
Available ACLs are basic IPv6 ACLs.
Rule ID
Select the Rule ID option and enter a number for the rule.
If you do not specify the rule number, the system assigns one automatically.
IMPORTANT:
If the rule number you specify already exists, the following operations modify the
configuration of the rule.
Operation
Select the operation to be performed for IPv6 packets matching the rule.
• Permit—Allows matching packets to pass.
• Deny—Drops matching packets.
Check Fragment
Select this option to apply the rule to only non-first fragments.
If you do no select this option, the rule applies to all fragments and
non-fragments.
Check Logging
Select this option to keep a log of matching IPv6 packets.
A log entry contains the ACL rule number, action on the matching packets,
protocol that IP carries, source/destination address, source/destination port
number, and number of matching packets.
To Next Page
Loading...
Need help?
General
