Honeywell VideoBloX User Manual

Honeywell
101
- Keyboard Function buttons (Record, Pause, Rewind, Forward, Play, and Stop)
control VCR.
- On completion of a review by an operator, the operator should ensure that the
tape is wound to the correct position before setting the VCR back into record
mode.
• VCR monitoring and Re-routing System
- When a VCR is recording, the view will show an asterisk (*).
- If the VCR is stopped (by an operator, tape change, or VCR fault), the view will
show the standby VCR which is recording the view (i.e., [1234 -> 3025]).
- If there are no standby VCRs, recording of the view will be lost and the view will
show [No backup VCR].
- VCRs which are not recording (and re-routed) can be viewed as a list on any
monitor using the diagnostic output.
VST DVR Control
Figure 3-44 VST DVR Control
• VST – Number
- The VST recording is only available on the working monitors.
- The VST number to control corresponds to the monitor number.
- Keyboard Function buttons (Record, Pause, Rewind, Forward, Play, Stop)
will control VST recorder
- A VST recorder has no standby recorder and it continues to record while a
review is in progress.
Honeywell Ademco MUX Control

Honeywell VideoBloX Specifications

General

Brand	Honeywell
Model	VideoBloX
Category	Matrix Switcher
Language	English