Honeywell VideoBloX User Manual

Honeywell
81
Steps for Configuring User Keys
1. On the User screen, select the Keys tab on the right side of the window.
Choose either User Keys, F1-F8, or F9-F16 to continue configuration.
2. Select the User Key to be configured.
3. Determine whether a Sequence should be run or a Group should be called when the
key is selected.
• If a Sequence will be run, select the Sequence (by name or number) and edit it if
needed.
• If a Group will be called, select the group number.
4. Repeat steps 1-3 for any other user keys on this screen.
5. Select
to save/download all information from the current page.
6. Continue to other sub-level screens as needed to configure the remaining user keys.
7. Users should log out then log back in to see user configuration changes.
Users Access
The Users Access tab is used to configure access for the specified user.
From this screen, access can be set for Cameras, Monitors, Keyboards, Sequences,
Functions, and Devices.
The functionality for each screen is the same; therefore, only the screen for Cameras will
be shown.
NOTE: User capabilities are also related to keyboard permissions/functions.

Honeywell VideoBloX Specifications

General

Brand	Honeywell
Model	VideoBloX
Category	Matrix Switcher
Language	English