Honeywell VideoBloX User Manual

Honeywell
83
Steps for Configuring User Access
1. From the User screen, select the Access tab. Choose from the sub-levels available:
Cameras, Monitors, Keyboards, Sequences, Functions, or Devices.
2. Set access for each user using the following methods:
• Click on the Access button to include this user in / exclude this user from ALL
groups. (Include = 9 / Exclude = U). Click on the Access button again to toggle
between include/exclude settings.
• Click on a Group column or on an individual cell (in the Access row) on the table
to include this user in / exclude this user from the particular group. (Include = 9 /
Exclude = U).
Click on the Group again to toggle between include/exclude settings.
Users can be in more than one group at a time.
3. Select
to save/download all information from the current page.
4. Repeat steps 1-3 as needed to configure user access in any of the remaining sub-
levels.
5. Users should log out then log back in to see user configuration changes.
Users Notes
The Users Notes tab is used to enter any notes applicable to the user.
Figure 3-25 Users – Notes Configuration
Heading
Notes tab

Honeywell VideoBloX Specifications

General

Brand	Honeywell
Model	VideoBloX
Category	Matrix Switcher
Language	English