VideoBloX MODULES
24
Figure 2-26 Software Version
9. To upgrade the NETOSD firmware, click UPGRADE tab. Figure 2-13 is displayed,
prompting you to make sure that the network is connected during file upgrade.
10. Click OK.
11. Refer to corresponding part in NETCPU Firmware Upgrade to upgrade NETOSD
firmware, change password and logout.
NOTE: In case that you forget the password, set SW8 of switch 4 to “1” to reset
password to default value (hvs). Refer to DIP Switch Settings on page 10 for detailed
information.
VIDEO INPUT MODULES
The video input module brings 16 video signals into the VideoBloX chassis. Each of the
inputs may be routed to 1 or more of the 64 backplane channels. All input modules have
16 video inputs, but can be switched to 16, 32, or 64 (maximum) outputs. They have
internal terminal switches.
Video Input Module Description
HVBM16 16 Inputs switch to 16 outputs
HVBM32 16 Inputs switch to 32 outputs
HVBM64 16 Inputs switch to 64 Outputs
To Next Page
Loading...
Need help?
General
