117
Figure 105 Adding rules to an SNMP view
4. Configure the parameters as described in Table 34.
5. Click Apply.
NOTE:
You can also click the icon corresponding to the specified view on the page as shown in Figure 102,
and then you
can enter the page to modify the view.
Configuring an SNMP community
1. Select Device > SNMP from the navigation tree.
2. Click the Community tab.
The Community tab appears.
Figure 106 Configuring an SNMP community
3. Click Add.
The Add SNMP Community page appears.
To Next Page
Loading...
Need help?
General
