HP 1920 Gigabit Ethernet Switch Series User Manual

453
Ste
p
Remarks
3. Configuring a rule for a basic IPv4 ACL.
Required.
Complete one of the following tasks according to
the ACL category.
4. Configuring a rule for an advanced IPv4 ACL.
5. Configuring a rule for an Ethernet frame header ACL.
Recommended IPv6 ACL configuration procedure
Ste
p
Remarks
1. Configuring a time range.
Optional.
Add a time range. A rule referencing a time range takes
effect only during the specified time range.
2. Adding an IPv6 ACL.
Required.
Add an IPv6 ACL. The category of the added IPv6 ACL
depends on the ACL number that you specify.
3. Configuring a rule for a basic IPv6 ACL.
Required.
Complete one of the tasks according to the ACL category.
4. Configuring a rule for an advanced IPv6 ACL.
Configuring a time range
1. Select QoS > Time Range from the navigation tree.
2. Click the Add tab.
Figure 445 Adding a time range
3. Configure a time range as described in Table 137.

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English