155
Configuration guidelines
When you configure VLAN interfaces, follow these guidelines:
• A link-local address is automatically generated for an IPv6 VLAN interface after an IPv6 site-local
address or global unicast address is configured for the VLAN interface. This generated link-local
address is the same as the one generated in the Auto mode. If a manually assigned link-local
address is available, the manually assigned one takes effect. After the manually assigned link-local
address is removed, the automatically generated one takes effect.
• For an IPv6 VLAN interface whose IPv6 link-local address is generated automatically after you
assign an IPv6 site-local address or global unicast address, removing the IPv6 site-local address or
global unicast address also removes the generated IPv6 link-local address.
• For IPv6 link-local address configuration, manual assignment takes precedence over automatic
generation. If you first adopt the manual assignment and then the automatic generation, the
automatically generated link-local address will not take effect and the link-local address of the
interface is still the manually assigned one. However, if you remove the manually assigned one, the
one automatically generated takes effect.
To Next Page
Loading...
Need help?
General
