HP 1920 Gigabit Ethernet Switch Series User Manual

29
reboot
Syntax
reboot
Parameters
None
Description
Use reboot to reboot the device and run the main configuration file.
Use the command with caution because reboot results in service interruption.
If the main configuration file is corrupted or does not exist, the device cannot be rebooted with the reboot
command. In this case, you can specify a new main configuration file to reboot the device, or you can
power off the device, and then power it on, and the system will automatically use the backup
configuration file at the next startup.
If you reboot the device when file operations are being performed, the system does not execute the
command to ensure security.
Examples
# If the configuration does not change, reboot the device.
<Sysname> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# If the configuration changes, reboot the device.
<Sysname> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Current configuration will be lost in next startup
if you continue. Continue? [Y/N]:y
Now rebooting, please wait...
summary
Syntax
summary
Parameters
None
Description
Use summary to view the summary of the device, including the IP address of VLAN-interface 1, and
software version information.
Examples
# Display summary information about the device.
<sysname>summary

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English