EasyManua.ls Logo

HP 1920 Gigabit Ethernet Switch Series

HP 1920 Gigabit Ethernet Switch Series
547 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
291
round-trip min/avg/max = 62/62/63 ms
Configuration guidelines
When you configure a static route, follow these guidelines:
If you do not specify the preference, the default preference will be used. Reconfiguration of the
default preference applies only to newly created static routes. The Web interface does not support
configuration of the default preference.
If you specify the next hop address first and then configure it as the IP address of a local interface,
such as a VLAN interface, the static route does not take effect.
When you specify the output interface, note the following:
{ If the output interface is NULL 0 or a loopback interface, no next hop address is required.
{ If the output interface is a broadcast interface (such as a VLAN interface), you must specify the
output interface and the next hop at the same time.
You can delete only IPv4/IPv6 static routes on the Remove tab.

Table of Contents

Related product manuals