HP 1920 Gigabit Ethernet Switch Series User Manual

123
Item Descri
p
tion
Security Name
Set the security name, which can be an SNMPv1 community name, an
SNMPv2c community name, or an SNMPv3 user name.
UDP Port
Set UDP port number.
IMPORTANT:
The default port number is 162, which is the SNMP-specified port used for
receiving traps on the NMS. Generally (such as using IMC or MIB Browser as the
NMS), you can use the default port number. To change this parameter to another
value, you need to make sure the configuration is the same with that on the NMS.
Security Model
Select the security model, for which you must set the SNMP version. For the
NMS to receive notifications, make sure the SNMP version is the same with that
on the NMS.
Security Level
Set the authentication and privacy mode for SNMP traps when the security
model is selected as v3. The available security levels are: no authentication no
privacy, authentication but no privacy, and authentication and privacy.
When the security model is selected as v1 or v2c, the security level is no
authentication no privacy, and cannot be modified.
Displaying SNMP packet statistics
Select Device > SNMP from the navigation tree.
The page for displaying SNMP packet statistics appears.
Figure 114 SNMP packet statistics

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English