HP 1920 Gigabit Ethernet Switch Series User Manual

211
Setting LACP priority
1. From the navigation tree, select Network > LACP.
2. Click Setup.
3. In the Set LACP enabled port(s) parameters area, set the port priority, and select the ports in the
chassis front panel.
4. Click Apply in the area.
Figure 190 Setting the LACP priority
Table 66 Configuration items
Item Descri
p
tion
Port Priority Set a port LACP priority.
Select port(s) to
apply Port Priority
Choose the ports where the port LACP priority you set will apply on the chassis front panel.
You can set LACP priority on both LACP-enabled ports and LACP-disabled ports.
5. In the Set global LACP parameters area, set the system priority.
6. Click Apply in the area.
Displaying LACP-enabled port information
1. From the navigation tree, select Network > LACP.
The default Summary tab appears. The upper part of the page displays a list of all LACP-enabled
ports on the device and information about them. Table 67 describes the fields.
2. Select a port on the port list.
3. Click View Details.

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English