HP 1920 Gigabit Ethernet Switch Series User Manual

210
2. Choose an aggregate interface from the list.
The list on the lower part of the page displays the detailed information about the member ports of
the link aggregation group.
Figure 189 Displaying information of an aggregate interface
Table 65 Field description
Field Descri
p
tion
Aggregation interface
Type and ID of the aggregate interface.
Bridge-Aggregation indicates a Layer 2 aggregate interface.
Link Type Type of the aggregate interface: static or dynamic.
Partner ID ID of the remote device, including its LACP priority and MAC address.
Selected Ports
Number of Selected ports in each link aggregation group (Only Selected ports
can send and receive user data).
Standby Ports
Number of Unselected ports in each link aggregation group (Unselected ports
cannot send or receive user data).
Member Port
A member port of the link aggregation group corresponding to the target
aggregate interface.
State Aggregation state of a member port: Selected or Unselected.
Reason for being Unselected
Reason why the state of a member port is Unselected. For a Selected port, this
field displays a hyphen (-).

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English