HP 1920 Gigabit Ethernet Switch Series User Manual

40
Task Remarks
Configuring member devices of a stack:
Configuring stack ports
Required.
Configure a port of a member device that connects to the master
device or another member device as a stack port.
By default, a port is not a stack port.
Displaying topology summary of a stack
Optional.
Display information about stack members.
Displaying device summary of a stack
Optional.
Display the control panels of stack members.
IMPORTANT:
Before viewing the control panel of a member device, you must make
sure the username, password, and access right you used to log on to
the master device are the same with those configured on the member
device; otherwise, the control panel of the member device cannot be
displayed.
Logging in to a member device from the
master
Optional.
Log in to the Web network management interface of a member
device from the master device.
IMPORTANT:
Before logging in to a member device, you must make sure the
username, password, and access right you used to log on to the
master device are the same with those configured on the member
device. Otherwise, you cannot log in to the member device. You can
configure them by selecting Device and then clicking Users from the
navigation tree.
Configuring global parameters of a stack
Select Stack from the navigation tree to enter the page shown in Figure 26. You can configure global
parameters of a stack in the Global Settings area.

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English