319
Figure 295 Ping operation result
Traceroute operation
The Web interface does not support IPv6 traceroute.
Before performing a traceroute operation, perform the following tasks:
• Enable sending of ICMP timeout packets by executing the ip ttl-expires enable command on
intermediate devices.
• Enable sending of ICMP destination unreachable packets by executing the ip unreachables enable
command on the destination device.
To perform a traceroute operation:
1. From the navigation tree, select Network > Diagnostic Tools.
2. Click the Trace Route tab.
The traceroute configuration page appears.
Figure 296 Traceroute configuration page
To Next Page
Loading...
