HP 1920 Gigabit Ethernet Switch Series User Manual

209
Figure 188 Creating a link aggregation group
3. Configure a link aggregation group as described in Table 64.
4. Click Apply.
Table 64 Configuration items
Item Descri
p
tion
Enter Link Aggregation
Interface ID
Assign an ID to the link aggregation group to be created.
You can view the result in the Summary area at the bottom of the page.
Specify Interface Type
Set the type of the link aggregation interface to be created:
• Static—LACP is disabled.
• Dynamic—LACP is enabled.
Select port(s) for the link
aggregation interface
Select one or multiple ports to be assigned to the link aggregation group from
the chassis front panel.
You can view the result in the Summary area at the bottom of the page.
Displaying aggregate interface information
1. From the navigation tree, select Network > Link Aggregation.
The default Summary tab appears. The list on the upper part of the page displays information
about all the aggregate interfaces.

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English