HP 1920 Gigabit Ethernet Switch Series

411
Figure 394 Configuring MAC authentication globally
2. Configure MAC authentication for GigabitEthernet 1/0/1:
a. In the Ports With MAC Authentication Enabled area, click Add.
b. Select GigabitEthernet1/0/1 from the Port list, and click Apply.
Figure 395 Enabling MAC authentication for port GigabitEthernet 1/0/1
ACL assignment configuration example
Network requirements
As shown in Figure 396, the switch uses RADIUS servers to perform authentication, authorization, and
accounting.
Configure MAC authentication on port GigabitEthernet 1/0/1 to control Internet access. Make sure an
authenticated user can access the Internet but not the FTP server at 10.0.0.1.
Use MAC-based user accounts for MAC authentication users. The MAC addresses are not hyphenated.