216
• Do not assign the following types of ports to Layer 2 aggregate groups:
{ MAC address authentication-enabled ports.
{ port security-enabled ports.
{ packet filtering-enabled ports.
{ Ethernet frame filtering-enabled ports.
{ IP source guard-enabled ports.
{ 802.1X-enabled ports.
• Deleting a Layer 2 aggregate interface also deletes its aggregation group and causes all member
ports to leave the aggregation group.
• When a load sharing aggregation group becomes non-load-sharing because of insufficient load
sharing resources, one of the following problems might occur:
{ The number of Selected ports of the actor is inconsistent with that of the partner, which might
result in incorrect traffic forwarding
{ The peer port of a Selected port is Unselected, which might result anomalies in upper-layer
protocol and traffic forwarding.
To Next Page
Loading...
Need help?
General
