HP 1920 Gigabit Ethernet Switch Series User Manual

10
Function menu Descri
p
tion
User level
Switch To
Management
Switch the current user level to the management
level.
Visitor
Loopback Loopback Perform loopback tests on Ethernet interfaces. Configure
VCT VCT
Check the status of the cables connected to Ethernet
ports.
Configure
Flow
Interval
Port Traffic
Statistics
Display the average rate at which the interface
receives and sends packets within a specified time
interval.
Monitor
RMON
Statistics
Display, create, modify, and clear RMON
statistics.
Configure
History
Display, create, modify, and clear RMON history
sampling information.
Configure
Alarm Display, create, modify, and clear alarm entries. Configure
Event Display, create, modify, and clear event entries. Configure
Log Display log information about RMON events. Configure
Energy
Saving
Energy Saving
Display and configure the energy saving settings of
an interface.
Configure
SNMP
Setup
Display and refresh SNMP configuration and
statistics information.
Monitor
Configure SNMP. Configure
Community
Display SNMP community information. Monitor
Create, modify, and delete an SNMP community. Configure
Group
Display SNMP group information. Monitor
Create, modify, and delete an SNMP group. Configure
User
Display SNMP user information. Monitor
Create, modify, and delete an SNMP user. Configure
Trap
Display the status of the SNMP trap function and
information about target hosts.
Monitor
Enable or disable the SNMP trap function; create,
modify, and delete a target host.
Configure
View
Display SNMP view information. Monitor
Create, modify, and delete an SNMP view. Configure
Interface
Statistics
Interface
Statistics
Display and clear the statistics information about
an interface.
Configure

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English