HP 1920 Gigabit Ethernet Switch Series User Manual

282
The page for configuring an IPv6 static route appears.
Figure 257 Creating an IPv6 static route
3. Create an IPv6 static route as described in Table 93.
4. Click Apply.
Table 93 Configuration items
Item Descri
p
tion
Destination IP Address
Enter the destination host or network IP address, in the X:X::X:X format. The
128-bit destination IPv6 address is a hexadecimal address with eight parts
separated by colons (:). Each part is represented by a 4-digit hexadecimal
integer.
Prefix Length Enter or select the prefix length of the destination IPv6 address.
Preference
Set a preference value for the static route. The smaller the number, the higher the
preference.
For example, specifying the same preference for multiple static routes to the same
destination enables load sharing on the routes. Specifying different priorities for
them enables route backup.
Next Hop Enter the next hop address, in the same format as the destination IP address.
Interface
Select the output interface.
You can select any available Layer 3 interface, for example, a virtual interface,
of the device. If you select NULL 0, the destination IPv6 address is unreachable.

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English