HP 1920 Gigabit Ethernet Switch Series User Manual

284
Figure 259 Configuring a default route
2. Configure a static route to Switch A and Switch C on Switch B:
a. Select Network > IPv4 Routing from the navigation tree of Switch B.
b. Click the Create tab.
The page for configuring a static route appears.
c. Enter 1.1.2.0 for Destination IP Address, 24 for Mask, and 1.1.4.1 for Next Hop.
d. Click Apply.

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English