HP V1910 Switch Series - Page 277

263
Figure 229 Configure a default route
# Configure a static route to Switch A and Switch C respectively on Switch B.
 Select Network > IPv4 Routing from the navigation tree of Switch B, and then click the Create tab
to enter the page shown in Figure 230.
 Type 1.1.2.0 for Destination IP Address.
 Select 24 (255.255.255.0) from the Mask drop-down list.
 Type 1.1.4.1 for Next Hop.
 Click Apply.
 Type 1.1.3.0 for Destination IP Address.
 Select 24 (255.255.255.0) from the Mask drop-down list.
 Type 1.1.5.6 for Next Hop.
 Click Apply.